The trick you have to know to remove the fat from the grid of your kitchen extractor

The extractor bell is a fundamental element of the kitchen and, at the same time, one of the areas where, although it does not seem like it, more dirt accumulates.However, it is also a part that is usually forgotten when cleaning and which, its difficulty for this does not help.Thus, these are the best tricks to clean the extractor bell of your kitchen quickly and easily.

Remove the fat from

To remove the fat from the extractor bell, it is recommended to use degreaser, and that is that cleaning the interior of the device is as complicated as necessary, since it helps a lot to its correct operation.

The degreaser has to be stainless steel, so as not to damage the bell.First you have to remove the filters, then give it to the interior with a good layer of degreaser.Then you have to let act for a few minutes to, then pass a cloth or scourer through the area.It is likely that in the first pass it will not be completely clean, so you must repeat the process.

Of course, use sodium bicarbonate

It is the multipurpose par excellence when cleaning the house and, the case of the extractor bell is no exception.To clean it inside, this trick is perfect to even remove the dirt inside the engine.In this case, you must first heat the sodium bicarbonate in a couple of pots with water.Once the water begins to boil the extractor turns on.Once this is done, let the steam rise and get into the device to clean it, leave it for an hour and, as you get empty you are throwing water and bicarbonate.You will see that the bell fat begins to fall.

After approximately an hour, turn off the fires and protégelos with absorbent paper so that they do not stain the fat and start cleaning the extractor with a cloth.Also use a brush that carries a mixture of bicarbonate and water for some areas and finishes cleaning the cloth again.

Don't forget the filters

To clean the filters you can put them in the dishwasher, but, but, you can put them in a sweep with water and degreaser for a few minutes.Then take them out and pass a rag through the fat, which will have been soft and, in the most complicated areas, use a toothbrush.

Also clean on the outside

To leave the definitive aspect you have to finish off the outside.This must be done by turning out the extractor first.Then you must take a specific cleaner for stainless steel and throw it across the surface, taking care in the buttons area.It is allowed to act for a few seconds and then a rag is passed in the same direction through which the cleaner has been thrown, which makes the brightness enhanced and the appearance of marks is avoided.