The dishwasher is one of the appliances that are used almost daily in the home and whose performance depends on the fact that it is very clean, since if the device accumulates dirt, its effectiveness could be reduced and the cleaning result of the dishes may not be optimal.
In this way, it is convenient to carry out clean.In general, it is convenient to empty the filter basket as long as it has remains, brush the large filter at least once a month and clean the blades a couple of times a year, as indicated by the organization of consumers and users.
First, you have to know that the dishwasher have a filter that is located in the lower area of the inner bucket.This serves to collect the remains of dirt so that they do not go to the drainage.Normally it consists of two pieces: a plastic basket that retains the largest waste and, around it, a perforated metal surface.
The filter should be removed once a week if the dishwasher is used frequently, for which you have to remove the lower tray until the bottom of the device is seen.Then, you have to turn the plastic basket in the opposite direction to the clock needles: the plate will be loose, you have to pull up and it can be removed.
Once outside, you will have to remove the waste inside the basket and rinse it well with water until you remove all the fragments.You will also have to clean the metal plate, rubbing it with a brush with water and a few drops of soap or a scourer to remove all dirt.
If the filter were very dirty, you can let up 30 minutes in hot water.When replacing it, the basket must be turned in the direction of the clock needles so that it is blocked.
Likewise, it is advisable.
In this way, it will be enough to pass a damp cloth and dry it with a kitchen paper.You have to also check the lanes and check that they are easily slid.
Cleaning the joints is very simple, since you just have to pass a damp cloth through the rubber of the dishwasher door, since there you can also accumulate remains of food or even mold.If it is difficult to access any fold, a small brush can be used.
The sponsor arms or arms of the dishwasher can get very easily.This cleaning must be done twice a year to remove any obstruction that prevents the water from going out through the holes.They usually go to thread or simply under pressure.
Once they are out, you have to clean them with soap and water under the tap or with a degreaser.You have to avoid remains in the holes by which water is thrown.To facilitate this task, in some models, the blades can be opened, separating them into two halves.
If they cannot be opened, they can be put in a sweep with very hot water and then put them under the jet of tap water so that the dirt out of its interior comes out, causing the water between the holes.
To perform this cleaning, a cleaning product is needed that can be found in supermarkets.Thus, you just have to follow the instructions for use.Usually, it is enough to open the cleaning product cleaning, place it upside down in the cutlery basket inside the empty dishwasher, close the door and schedule the washing cycle recommended by the clean machines manufacturer.
According to the use that you give to the machine, it is recommended to do this cleaning of ducts once every month or every two months and also after long periods without using it.
Finally, every time a washing ends it is important to leave the door open so that the entire humidity comes out thus avoiding the formation of mold and bad odors inside.
Likewise, the OCU also recommends cleaning the dishwasher on the outside, for which no special care is required, since the same products can be used as for the rest of the kitchen furniture.
However, some considerations should be taken into account when cleaning or maintaining certain parts of this appliance:
1807